20 November 2026

Cycling holidays in the Alps: what condition are your car’s brakes in after tackling the mountain passes?

Galibier, Izoard, Iseran… In summer, the Alpine passes attract cycling enthusiasts who come to test themselves on their slopes. Many transport their bikes by car to their holiday destination, then to the starting points of their rides. Between the winding roads, the long descents and the kilometres that add up, the brakes are put under a lot of strain. After several weeks of driving in the Alps, what condition are your car’s brake pads in?

Car journeys to reach the cycle start points

Have you chosen Valloire, Briançon or Bourg-Saint-Maurice for your cycling holiday? You may well have several legendary climbs on your itinerary. But not all of them start right outside your accommodation. To reach the start of a route in another valley, you’ll need to get back behind the wheel. Between the passengers, luggage and bikes, your car may be much more heavily laden than usual. However, on mountain roads, this extra weight increases the energy that the brakes have to dissipate, particularly on long descents.

At the Galibier, a vertical drop of nearly 600 metres separates the summit, at an altitude of 2,642 metres, from the Col du Lautaret, about nine kilometres below. Further south, the descent from the Izoard towards Briançon stretches for nearly 19 kilometres, with a vertical drop of around 1,170 metres.

If you tend to keep your foot on the brake pedal rather than using engine braking, these long downhill stretches put a lot of strain on the brake discs and pads. This habit can drive up your maintenance costs, even if the brake pad prices varies depending on your vehicle.

Why do downhills cause brakes to wear out more quickly?

Every time you brake, the brake pads rub against the discs and gradually wear down. On Alpine roads, there are frequent opportunities to slow down: a tight hairpin bend, a group of cyclists on the climb or an oncoming vehicle on a narrow road. This repeated braking accelerates pad wear, especially when your car is fully loaded.

On the northern slope of the Col de la Colombière, with some sections reaching a gradient of 10.5 per cent. Further south, the Route de la Bonette winds its way through a series of hairpin bends, with sections at 9 or 10 per cent. On these particularly steep sections, prolonged use of the brakes can cause heat to build up. Excessive heat can then temporarily reduce braking efficiency: this is the phenomenon known as fading. This overheating does not necessarily indicate brake pad wear, but poses a danger on steep roads.

What are the signs of worn brake pads?

Whilst you were tackling one cycle climb after another, your car also faced a few inclines. On your return journey, several changes in your car’s behaviour may indicate worn brake pads or another braking problem:

  • A metallic grinding noise or a persistent whining sound when braking.
  • Unusual vibrations in the accelerator pedal or steering wheel.
  • A pedal that has become abnormally soft or stiff.
  • A wear warning light illuminated on the dashboard, if the vehicle is fitted with one.
  • A noticeable reduction in braking efficiency.

These faults do not necessarily stem from the brake pads. A damaged disc, a seized caliper or a hydraulic fault can produce similar symptoms. If the vehicle is no longer braking normally, you must bring it to a safe stop and seek professional assistance.

Another consequence of replacing them too late is that, once the lining is completely worn out, the metal backing of the pad can damage the disc. The repair then goes beyond simply replacing the brake pads.

When should you have your braking system checked?

The manufacturer’s recommendations remain the benchmark for maintenance. As a guide, AD recommends checking the brake pads from 20,000 kilometres, then regularly at each service (1). However, frequent journeys on mountain roads, steep gradients and the vehicle’s load can accelerate wear and tear. An early check may therefore be warranted after a season spent driving over Alpine passes.

A workshop inspection focuses on the thickness of the brake linings, the condition of the discs and the operation of the calipers. Depending on the wear observed, the mechanic determines which parts need replacing. Brake pads are replaced in sets on the same axle.

With over 2,300 multi-brand garages and body shops, AD provides these maintenance and repair services. The network offers a 24-month warranty on parts and labour.

So you can plan your next cycling trips with one less thing to worry about: your car’s brakes. The Alpine passes are challenging enough once you’re in the saddle!